End User Licence

AllyCAD

Copyright (C) 2017 Knowledge Base Sales (Pty) Ltd

Block I, The Terraces

Steenberg Office Park

Tokai 7945

South Africa

 

All Rights Reserved

 

LICENSE AGREEMENT

You should carefully read all the following terms and conditions before using this software. Your use of this software indicates your acceptance of this license agreement and warranty.

USAGE

The purchaser (hereafter referred to as the Licensee) hereby accepts from Knowledge Base Software (Pty) Ltd (hereafter referred to as the Licensor) a non-exclusive, non-transferable licence to use the software, AllyCAD, subject to the following conditions:

  1. The license fee shall be payable in advance and this agreement commences on said date of purchase.

  2. A separate license fee is payable for each computer upon which the Licensee wishes to have simultaneous use of the software.

  3. It is the Licensee's responsibility to insure the program for the full current replacement value.  In the event of theft or loss of the program, security disk or security module, or damage to any of the foregoing, the license must be re-purchased in full. If only media replacement is required then a shipping fee will be applicable.

  4. The Licensee undertakes not to copy, except for backup purposes, reproduce, translate, adapt, vary or modify the software, nor to communicate the software to any third party other than the Licensee's employees, without the Licensor's prior written consent. The Licensee also undertakes not to bypass or attempt to bypass the security measures incorporated in and supplied with the program by any means whatsoever, including third-party applications purporting to be a back-up system for hardware security devices.

  5. The Licensee undertakes, in cases where the program is supplied with a security device to prevent illegal copying, not to circumvent such security device. Evidence of circumvention of said security device, where supplied, shall lead to a criminal case being opened against the Licensee.

  6. The Licensee agrees that it shall not itself - nor through any subsidiary, agent or third party - sell, lease, license, sub-license or otherwise deal in the software.

  7. The Licensee acknowledges that any and all of the intellectual property rights including trademark, trade name, copyright and all other rights used or embodied in or associated with the software remain the sole property of the Licensor and its principals.

  8. The Licensee shall not question or dispute the ownership of any such rights at any time.

  9. No warranty of any kind is expressed or implied with regard to the use or application of the software or its fitness for any particular purpose. The verification of all results and output is entirely the responsibility of the purchaser.

  10. While every care has been taken in the preparation of the AllyCAD program and its manuals, Knowledge Base Software (Pty) Ltd, its employees and agents shall not be liable for any loss or damage (including in particular, consequential losses, loss of profits and penalties) suffered by the Licensee arising from any cause whatsoever in connection with the AllyCAD program or the use thereof whether such loss or damage results from breach of contract (including a fundamental breach), negligence or any other cause and whether or not this contract is at any time cancelled by the Licensee.

GOVERNING LAW

This agreement shall be governed by the laws of South Africa and International software laws.